Power Gear Leveling System Troubleshooting
Power gear leveling system troubleshooting. It will signal that it has completed the process by illuminating the center green Power Gear LEVEL light. This should also fix most problems and errors that you were getting previously as the process refreshes the memory of your device. 3 Press and hold the All Corners Raise All Corners Lower for about 10 seconds until the Auto Manual lights flash.
Visually inspect jacks to ensure all pads are touching ground. ThePowerGearlevelingsystemonyourcoachisdesignedandbuilttogiveyou yearsoftroublefreelevelingandstabilizingoperationThePowerGearsystem reflectsthelateststateofthearttechnologyinbothhydraulicandelectronic components. No power from battery to pump.
- Turn on PowerGear system - System check lights flash low voltage comes on and goes away - Left light flashes and stays flashing - Press Auto - Left and. This is important and necessary to allow the. However leveling can still be executed as normal to stabilize the coach.
Please avoid movement in the coach during automatic leveling as it can cause errors in the results. Never lift the wheels off the ground to level the coach. POWER GEAR LEVELING SYSTEM JACK IDENTIFICATION 1.
Use visual cues number of mounting holes type of footpad etc to identify. Repair For Slow Retraction Of Leveling Jacks-Damon. All Level LED is blinking Cause.
2 Ignition on and all lights on the Power gear panel off except the power light. Set the parking brake make sure that coach is in park or neutral and start the engine. Hydraulic Leveling Troubleshooting Flowchart Page 3.
If there is power to the board and nothing on the panel working then most likely the board is the issue. Turn power off to leveling system by pushing ONOFF button.
Installation Calibration for Electric Leveling Control 140-1224 Rev OG.
Installation and Calibration for Electric Leveling Control 140-1224 Rev OK. However leveling can still be executed as normal to stabilize the coach. Installation Calibration for Electric Leveling Control 140-1224 Rev OG. POWER GEAR LEVELING SYSTEM JACK IDENTIFICATION 1. Troubleshooting Information on Power Gear 1217 E. With 12 volts always present at one side of the solenoid coming from the battery bank. Visually inspect jacks to ensure all pads are touching ground. Push the AUTO button. Attempts to change tires while supporting the vehicle with the hydraulic system could result in damage to the motor home andor cause serious injury or even death.
Connect the cable to the side with no 12 volts then you can just tap the hot terminal. Please avoid movement in the coach during automatic leveling as it can cause errors in the results. Testing the system 1. Never lift the wheels off the ground to level the coach. I am going to look and see if there is anymore info I want to say at some point there was an issue with cycling the ignition key and this issue but I do not recall what chassis that was for. The system is now re-set. If no voltage is measured check for 12vdc at the 8 pin connector on pin 7 purple pin 6 orange and pin 5 yellow at the control box.
Post a Comment for "Power Gear Leveling System Troubleshooting"